Home > Power >

LiPo Rider Pro

LiPo Rider Pro

Our Price: $14.95

Stock Status:(Out of Stock)

Product Code: POW12059P


Power your favorite electronic kit with green energy by attaching a small solar panel to this board. This works great with our LiPO batteries (2000mAh or 3000mAh), and this board becomes a power source for most USB devices!

The LiPo Rider Pro has 3 inputs: solar (4.8V to 6.5V), USB, or battery. It has a single USB output, to which you can attach your Arduino or other devices. The max output is 1000mA at 5V.

The LiPo Rider Pro board is the ideal green power solution for your outdoor sensor design. Attach the LiPo Rider Pro board to your sensor board and it can run on solar power for a very long time! You can even use it to charge your mobile phone, via the USB port.

The LiPo Rider Pro is extremely affordable and easy to use. No programming is required. Plug it in and it works. The internal charger IC handles all the power flow between the various components.

In case solar power is not sufficient, the microUSB port allows you to charge your lithium battery through USB. You can even program your Arduino without detaching it from the LiPo Rider Pro board.

  • Maximum 1A load output
  • Battery and Solar panel connector is JST 2.0
  • Stable 5V USB power supply regardless of source
  • Charge/Recharge algorithms built into chip
  • Charge Lithium Polymer Battery through solar power or USB
  • Stable supply voltage through either lithium battery or USB
  • 2 x USB ports let you program your kit while charging your Lithium battery
  • LED indications for battery status (full, charging, or low voltage)
  • 4 green LEDs to indicate battery capacity status
Please see product Wiki for more info.

Share your knowledge of this product. Be the first to write a review »