Home > Sensors, Components & Modules > Ethernet >

Power-over-Ethernet Module Regulator 802.3af

Power-over-Ethernet Module Regulator 802.3af

Alternative Views:

Our Price: $29.00

Stock Status:(Out of Stock)

Product Code: ARD-1007

Note: This regulator module is designed for use with commercial PoE systems such as Ethernet switches with 802.3af support that can push a nominal 48V down the wire.  If you want to use the Ethernet Shield or
with home-brew PoE equipment that runs at a lower voltage you may need to use the Power-over-Ethernet Module Regulator 14-24V or run the board with just the jumpers connected.

The 802.3AF Power-over-Ethernet regulator module mounts on our Ethernet Shield or EtherTen to allow it to accept power at a nominal 48V from commercial PoE injectors and switches (Power Sourcing Equipment, or PSE) that support the 802.3AF standard. This regulator module performs the necessary signalling to communicate with the PSE and indicate that the device connected to the network segment is capable of accepting power via the LAN, which causes the PSE to activate its power injection mode. The module then takes the power supplied by the PSE and pre-regulates it down to 7.5V before passing it through to your Arduino for the final drop to 5V.

For more background information please see Power-over-Ethernet For Arduino.

EtherTen PoE Power Regulator 28V
Our Price: $65.00
Our Price: $19.00
Freetronics EtherTen Arduino with Ethernet PoE Power Regulator 28V

Share your knowledge of this product. Be the first to write a review »