Home > Sensors, Components & Modules > Wireless >

Bluetooth Bee - Standalone (built-in Arduino)

Bluetooth Bee - Standalone (built-in Arduino)

Alternative Views:

Our Price: $23.50

Stock Status:In Stock

Product Code: WLS04051P

Save that extra Arduino you have lying around for another project, this two-for-one device has the Arduino built-in!  Bluetooth Bee with Arduino is an enhanced version of the Bluetooth Bee.  We added an onboard ATMEGA168 to it to make it a full-featured Arduino while maintaining the same footprint and instruction set as the Bluetooth Bee.  Plus, it still allows you to stack it on XBee Carrier,  XBee® Shield, and UartSBee for expansion or reprogramming


   Small footprint
   Identical settings and pairing methods as the Bluetooth Bee
   Software serial port adopted between the Bluetooth module and ATMEGA168
   Remains compatible with XBee Carrier, XBee® Shield, and UartsBee for expansion

Hardware Features:

   Typical -80dBm sensitivity
   +4dBm RF transmit power
   Fully qualified Bluetooth V2.0+EDR 3Mbps Modulation
   Operating voltage:  3.3v
   Built-in antenna

Software Features:

   Software serial port communication method
   Default Baud rate:  38400
   Supported Baud rate:  9600, 19200, 38400, 57600, 115200, 230400, 460800
   Under RTS/CTS data transmit-receive framework
   Auto connect the last device on power as default
   Auto-reconnect in 30 minutes after out-of-range disconnection
   Ability to disconnect via a rising edge on PC2
   Working status signal on PB2:  low – not working, high – working
   Paired-up status indicator on PIO 10(a red LED) and PIO 11(a blue LED):
       Paired:  red and blue blinks 1 time/2s in interval
       Unpaired:  blue blinks 2 times/sec
   Default pincode:  0000

Product Wiki

Grove - Xbee Carrier UartSbee V4
Our Price: $15.50
Our Price: $18.75
Grove - Xbee Carrier UartSbee V4

Share your knowledge of this product. Be the first to write a review »